How to setup Linux PC CCcam server under 1 hour ..

[horatyu]

tutorial youtube http://www.youtube.com/watch?v=Cs4TRGR1Nqc


easysurf.ro_CCcam.xls - 40.5 Kb


tutorial CCCAM



search on google.com





in limba romana
http://www.scribd.com/doc/13779069/CCCam-pe-scurt

[faxe2110]

@horatyu

I became it to work. I took Clarkconnect 4.3 and then it works. With Clarkconnect 5.0 and 5.1 I dossen´t became it to work.

Sir horatyu
Is it possible that i can change CCcam 2.0.10 to 2.1.2 or newer?? Where did i find files?? I have found some CCcam.x86 from a newer CCcam but it dosen´t work. Can you still help me and give me a link for this??

Thanks

[Gera3030]

I am new to this and am trying to configure newcs. Can anyone give me a hand? please. Thanks

[abakhiet]

Hola,
i need to ask you how can i connect my Receiver to that server via USB cable to act as a subscriber in my own server after doing the previous steps ...

[ataomega]

hello.

i'm almost newbie.

for setting up a cccam server what hardware is required? a DVB cart?
should i have high-speed internet with dedicated ip? may i use vpn with dedicated ip?
if dvb is required the dvb should have drivers for linux, yes? i have prof dvbs2 7500 usb

thanks

[Tody]

Hello!
I have a question... (because I`m a beginner)
I have a cccam linux server installed, but I don`t know where I must to write the N-line and the F-lines?
Please, help me - if you can!

[SuperSonic]

The N-lines & F-lines go in the same folder with the C-lines : cccam.cfg.