Kaon KSF-100SCO (focus)

[delta2k2]

Multumesc pentru ajutor , gobi2000.

In acest moment apar doua situatii:

1. Daca pun R_KAON-TEAM _HW-FF.0C.FF_Fech-071217_SW-03.00.00_EMU-5.8.194_CA-2.2.3_WWW.SAT.US.PN.bin
, porneste , se face ecranul alb la un moment dat si apoi moare de tot ; nu mai face absolut nimic

2. Daca pun pusKSF100SCO_HW-12.C0.A5_SW-02.00.02 FOCUSSAT ORIGINAL.bin , porneste , dar imi apare :



Din telecomanda pot intra in meniuri , dar nu-mi apare nici o litera / font


La conectarea cu Upgrade Tool :

[ Upgrade mode. ]

UPGRADE TOOL (V2.30) 22-MAR-2004 Patch
File open O.K.!
> Old version binary.
Engineer Mode
-. Target loader version :L 219
-----------> Front :: 74HC164 used (connector: 14pin)
-----------> Target 2M Flash.
-----------> Target AMD/ST FLASH(TOP).
Connect Success
//==================================================
// FileInfo: KSF-100 STA2, H/W(12.C0.A5), S/W(02.00.02)
// Target: L 219, u-C[0] , FLS[2M], KSF-100SCONV, H/W(12.C0.A5), S/W(03.00.10)
//==================================================
Target Model Mismatch : KSF-100SCONV
03.00.10: Software Version is High
-. STB Model : KSF-100 STA2
-. STB H/W Ver : 12.C0.A5
-. STB S/W Ver : 03.00.10
DownLoad Start
DownLoad Success
DownLoad CRC Check OK
Flash Write Start
Flash CRC Check OK
Upgrade End

COM1 Off !!! ("Enter" key to reconnect.)


Ce mai pot face ?

L.E. intre timp am aflat ca receptorul a picat dupa ce amicul meu a pus coduri noi si a dat OK

[grantec]

Master reset!!!
3x Chanell UP in front panel, No 1 the remote control .

[delta2k2]

Multumesc , grantec.
Ia comanda de master reset , reboot-eaza , dar apare din nou meniul fara litere , ca in foto de mai sus. Am pus si celalalt bin , dar si acolo se comporta identic.

Alte solutii ?

[grantec]

First, update BL219v4 and Universal Post-R_KAON TEAM _HW-FF.0C.FF_ ......
Firmware is loaded application KUP V3.1XP the engineer mode (press PAUSE on the keyboard of a PC and then upload fw)

[komoddo]

First, update BL219v4 and Universal Post-R_KAON TEAM _HW-FF.0C.FF_ ......
Firmware is loaded application KUP V3.1XP the engineer mode (press PAUSE on the keyboard of a PC and then upload fw)

se poate rezolva . contacteaza-ma pe mes

[delta2k2]

Am rezolvat , multumesc pentru ajutor.

[gelu_dh]

Am rezolvat , multumesc pentru ajutor.

Spune si tu cum poate are si altul o astfel de problema ,e bine sa invatam de la altii