Thanks:
0
Likes:
0
Dislikes:
0
-
Golden Member
- Rep Power
- 127
How to setup Crossepg {XEPGDB providers} on a USB stick
VU + How to configure Crossepg XEPGDB} {providers on a USB drive
As follows: -
Press the Menu button on the STB remote control and select Settings {1}
1.JPG
2} Then select CrossEPG {2}
2.JPG 3} Press the Configure button in this menu you can set the location to store the EPG data.
The best place is on a USB stick, because it is fast. You should see a menu similar to the {3}
3.JPG
4} Now press the RED button to save and you can return to the main menu CrossEPG.
Then you need to update XEPGDB suppliers, info page will look like this {4}
4.JPG
5} Now the provider list has been updated, so now select suppliers XEPGDB {5}
5.JPG
6} The menu XEPGDB suppliers, simply select the supplier (s) you want to download,
information page will look like this {6}
6.jpg
7} Now press the yellow button to get the three suppliers that have been selected.
* The first field generation (Solo, Duo,Uno and Ultimo), it is a good idea to choose only two or three suppliers as EPG data memory fills up very quickly *. The SOLO2 can select all packages without any problems. {7}
7.jpg
8} Now your EPG is ready to use {8}
8.jpg
9} To update the EPG, you can Navigatie CrossEPG to the main menu and select Download Now, if you press the green button @ STB remote control and use CrossEPG Downloader. {9}
9.JPG
9.1} After pressing CrossEPG Downloader will download the data, and then converts the loaded ready for use automatically. {9,1}
9.1.JPG
Above *** Guide can also be used to Rytec EPG packages, select Rytec instead XEPGDB and follow the above instructions ***
Thank EVO and Artorius for help with translation
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules