e2 Alien RC1

[joberuc]

@zildan
thanks, OK, i will try.

---------- Post added at 20:58 ---------- Previous post was at 20:45 ----------

@zildan
I try Power off, pause 5 min, power on, but not success.
I tried to boot Spark, this is OK. Then I tied 5 min power off,
I disconnected network and SPDIF, only connected antenna and HDMI,
when loading modules, my TV detect signal 720p and 50 Hz and then
restart. I do it with and without Kingston USB key.


Thanks for your next help.

joberuc

[zildan]

Reflash image and power off for long time (min 5 min) before first boot.
Image was tested before.

[joberuc]

@zildan
thanks, OK, i will try refresh and long power off for first time.

Has anyone the same problem?

[phys]

... multumim

[joberuc]

@zildan
I Reflash image and power off for long time (25 min) before first boot. But the same result. After loading modules reboot. Then I try flash RC1 with uImage form beta5, after flashing, boot - load modules - RSP was on display but no pictures on TV.
I am surprised with my reboots, because beta 5 work OK on my Alien.
At the end of my testing, I flash beta5 and it's OK, after reboot Enigma wizard so on.

I have Amiko Alien, i believe, that the same hardware is selling in Slovakia as your country.

I am grateful for any help.
Thanks.

joberuc

[zildan]

RC1 has a lot of kernel options off for speed up. I'll try to do a new version with old kernel settings

[joberuc]

Thanks for your work and help.

I connect Alien to terminal and prepare logs from serial port, may be helps.
Logs are from boot beta5, boot RC1 and flash RC1.

http://www.multiupload.com/7ULZ51XHLC