webcam on dd-wrt?

[resofty]

@zappa
da-ne te rog copy paste dupa ce inregistrezi spca5xx, ca faptul ca e "not claimed" e fiindca el inca nu are incarcat driverul.
plus ca deviceul dupa cate stiu eu e in /dev/v4l/video0

[zappa]

Aseara mi-a picat netul si nu am putut edita/adauga nimic. Normal ca am citit. Continui cu logul:

root@OpenWrt:/dev# lsmod | grep videodev
videodev 8016 0 spca5xx_lite

................................

root@OpenWrt:/lib/modules/2.4.37.5# insmod spca5xx
insmod: unresolved symbol __up
root@OpenWrt:/lib/modules/2.4.37.5#
.......................

root@OpenWrt:/lib/modules/2.4.37.5# dmesg | grep usb
usb.c: registered new driver usbdevfs
usb.c: registered new driver hub
usb.c: new USB bus registered, assigned bus number 1
usb.c: registered new driver usb-storage
usb-ohci.c: USB OHCI at membase 0xb8003000, IRQ 6
usb-ohci.c: usb-00:03.0, PCI device 14e4:4715
usb.c: new USB bus registered, assigned bus number 2
usb.c: new USB bus registered, assigned bus number 3
usb.c: new USB bus registered, assigned bus number 4
usb-uhci.c: $Revision: 1.275 $ time 18:57:24 Nov 8 2009
usb-uhci.c: High bandwidth mode enabled
usb-uhci.c: v1.275:USB Universal Host Controller Interface driver
usb.c: USB device 2 (vend/prod 0x46d/0x8da) is not claimed by any active driver.
usb.c: registered new driver spca5xx
drivers/usb/spca5xx.c: spca5xx driver 00.57.07 registered
root@OpenWrt:/lib/modules/2.4.37.5#
....
Driverul e incarcat. Cel pe care mi l-a dat resofty nu se incarca (da eroarea de mai sus). Cel de la macsat se incarca (si lite si full). O sa incerc sa schimb firmware-ul. Acum am OpenWrt Kamikaze bleeding edge, r18327.
O sa incerc iar dd-wrt, desi nu mai am sperante.

[prodigy]

m-am uitat prin sursa driverului si se pare ca are support pt camera ta:

{USB_DEVICE(0x046d, 0x08da)},       /* Logitech QuickCam Messenger */

- driverul de la resofy este compilat de mine pt kernel 2.4.35.4, dar lui i s-a incarcat pe dd-wrt,,,,deci trebuie pina la urma sa mearga si camera ta, in driver este suport 100%.

[zappa]

Dupa multe teste si sapaturi am reusit. Dar nu prin merite personale, ci doar cu un pic de curaj. Aici am gasit firmware dd-wrt modificat cu suport ptr webcam. Urmeaza sa testez sa vad daca reusesc sa fac sa mearga si pe openwrt (preferatul meu ).
Multumesc tuturor ptr. sustinere.

http://www.dd-wrt.com/phpBB2/viewtop...?p=99564#99564

root@DD-WRT:~# lsmod
Module Size Used by Tainted: P
quickcam 65464 0 (unused)
ov518_decomp 19516 0 (unused)
ov511_decomp 12396 0 (unused)
ov51x 87288 2 [ov518_decomp ov511_decomp]
spca5xx 649712 2
pwcx 103324 0 (unused)
pwc 47224 0 [pwcx]
videodev 8016 1 [quickcam ov51x spca5xx pwc]
uhci 30180 0 (unused)
ehci-hcd 20556 0 (unused)
usbcore 74808 0 [quickcam ov51x spca5xx pwc uhci ehci-hcd]
ip_nat_pptp 2364 0 (unused)
ip_conntrack_pptp 2956 1
ip_nat_proto_gre 1648 0 (unused)
ip_conntrack_proto_gre 2520 0 [ip_nat_pptp ip_conntrack_pptp]
wl 711360 0 (unused)
switch-robo 5548 0 (unused)
switch-core 6400 0 [switch-robo]

[zappa]

dmesg | grep usb
usb.c: registered new driver usbdevfs
usb.c: registered new driver hub
usb.c: new USB bus registered, assigned bus number 1
usb.c: new USB bus registered, assigned bus number 2
usb.c: new USB bus registered, assigned bus number 3
usb.c: registered new driver Philips webcam
usb.c: USB device 2 (vend/prod 0x46d/0x8da) is not claimed by any active driver.
usb.c: registered new driver spca5xx
drivers/usb/spca5xx.c: USB SPCA5XX camera found. Logitech QC Messenger
drivers/usb/spca5xx.c: [spca5xx_probe:5480] Camera type JPEG
drivers/usb/zc3xx.h: [zc3xx_config:558] Find Sensor HV7131R(c)
drivers/usb/spca5xx.c: [spca5xx_getcapability:1765] maxw 640 maxh 480 minw 176 minh 144
drivers/usb/spca5xx.c: spca5xx driver 00.60.00 registered
usb.c: registered new driver ov51x
usb.c: registered new driver quickcam

[goldsat]

am ajuns aici

usb.c: registered new driver spca5xx
drivers/usb/spca5xx.c: USB SPCA5XX camera found. Type Vimicro Zc301P 0x303b
drivers/usb/spca5xx.c: [spca5xx_probe:5480] Camera type JPEG
drivers/usb/zc3xx.h: [zc3xx_config:527] Find Sensor PB0330
drivers/usb/spca5xx.c: [spca5xx_getcapability:1765] maxw 640 maxh 480 minw 176 minh 144
drivers/usb/spca5xx.c: spca5xx driver 00.60.00.1 registered

si dupa ce dau

/opt/var/bin/w3camd -v -p 8999 -s 320x240 -h 192.168.10.1 -d /dev
/video

primesc :

main thread pid = 1263
bind 192.168.10.1:8999 to file descriptor 3
incoming connection..
serving connection, (childs=1)
w3camd.c: no. of childs changed: childs=1
/dev/video: No such file or directory
w3camd.c: can't init v4l
server_thread() state=0
connection closed

unde e problema

[goldsat]

sau asa :

root@DD-WRT:/dev# /opt/var/bin/./w3camd -v -p 8999 -s 640x480 -h 192.168.10.1 -d
/dev/video
main thread pid = 1574
bind 192.168.10.1:8999 to file descriptor 3
incoming connection..
serving connection, (childs=1)
w3camd.c: no. of childs changed: childs=1
/dev/video: No such file or directory
w3camd.c: can't init v4l
server_thread() state=0