Configurare Comutator Diseq 8/1!!!!!!

[adi sony]

DM500 + Gemini3.40 testat

EMP Centauri -> option1 (DiSEqC 1.1 mode)

Menu -> Setup -> Service Searching -> Satellite Configuration ->
-> non-standard user defined configuration

Sat/Position LNB 22Khz Voltage
--------------------------------------------------------
1. Sat xxxxxxx 0 Hi/Lo H/V
2. Sat xxxxxxx 1 Hi/Lo H/V
3. Sat xxxxxxx 2 Hi/Lo H/V
4. Sat xxxxxxx 3 Hi/Lo H/V
5. Sat xxxxxxx 4 Hi/Lo H/V
6. Sat xxxxxxx 5 Hi/Lo H/V
7. Sat xxxxxxx 6 Hi/Lo H/V
8. Sat xxxxxxx 7 Hi/Lo H/V
--------------------------------------------------------

<OK>


LNB Configuration:
--------------------------------------------------------

Sat/LNB mapping: LNB 0

LOF/L: 09750

LOF/H: 10600

Threshold: 11700

Increased voltage: No

12V output on: No

-------------------------------------------------------


se da <next page> si <OK> si se seteaza asa:



LNB Configuration: LNB0 LNB1 LNB2 LNB3 LNB4 LNB5 LNB6 LNB7

-------------------------------------------------------------------------------------

1. Toneburst: None None None None None None None None
2. DiSEqC Mode: 1.1 1.1 1.1 1.1 1.1 1.1 1.1 1.1

3. DiSEqC Parameter: 1 2 3 4 5 6 7 8
4. DiSEqC Reapeats: None None None None None None None None

5. Uncommitted Switch: Input1 Input2 Input3 Input4 Input5 Input6 Input7 Input8

6. Seguence repeat: No No No No No No No No
7. Swap Commands: No No No No No No No No

8. Fast DiSEqC: No No No No No No No No
--------------------------------------------------------------------------------------