MultiCAS-v1.70
MultiCAS-v1.70
-DATE : 2011/05/18
-Version : v1.70
--- How to use Re-Sharing of CCcam share ---
Use one CCcam account for more Azboxes with MultiCAS
1. Azbox connected to CCcam server
a. Get CCcam account.
b. Go to Plug-Ins->OpenXCAS->MultiCAS and smart Card Splitter & CS Menu
c. Select Mode as Server and set the sub-menu as follows ;
- My IP Address : this is the IP adres of your Azbox. This will be the server IP address in the client.
- Port : 3000 (default value) - Please set the value between 1000 and 9000.
- Time Out : 2.0 sec (default value). If you use more clients this time-out value must be higher. Please keep it below 4.0 seconds.
- Save the changed values by pressing RED button on RCU.
2. Client Azbox
a. Go to Plug-Ins->OpenXCAS->MultiCAS and Smart Card Splitter & CS Menu
b. and select Mode as Client and set the sub-menu as follows ;
- Server Domain Name Use : OFF (or ON if you use DNS.)
- Server IP Address : Set the IP address of the Server STB.
- Server Domain Name : If the Server Domain Name Use is ON, put the domain name.
(if you use local share between Azboxes in your house the Server IP Address will be like 192.168.xxx.xxx)
- Port : 3000 (default value) - Please set the same value with that of Server STB.
- Time Out : 1.0 sec (default value will 1.0 sec, but 3.0sec will be better)
- Check Server : Press OK button for checking the Server STB. If the server information is correct, you will see Server CAS ID : 0x0000.
- Save the changed values by pressing RED button on RCU.
- Go to TV and check the channel is working well.
- If you would have more sets to use Client please follow the above procedure again.
- If the TV channel on Client STB is not working please try to adjust the value of Time Out.
Update sau download cu MAZ
Reply With Quote
