How to flash your dreambox 600

How to flash your dreambox 600 ///

You can easily flash your DM-600 as follows.///

Important, You must know what IP address your DB will have.///

1: Turn on your dreambox in the communications page and note down the IP address your DB was assigned.///

2: Remove the power supply lead from the back of the dreambox, hold in the power/standby button, plug in the power supply again (While keeping the button pressed). Give it about 15 secs and flash should be erased.///

It only actually takes about 10 secs, You will notice that the flashing pattern on the LEDs will have changed.///

3: Open up your favorite web browser and type in the IP address you noted earlier. You will see a green page load. Click the link labeled 'upgrade firmware' (or similar) on the bottom left of the page. Browse to and select your the NFI image file on your PC. Click the button to proceed.///

4: Once the flash progress meter has reached 100%, turn the DB off then on again.///

That's it, You have a new image in flash.///