PDA

View Full Version : Starbox ITS-5400 2



resofty
28-01-09, 09:55
Care ma poate ajuta sa gasesc firmware pentru StarBox II ITS-5400?
Eu am gasit ceva pe niste forumuri turcesti , dar nu prea ofera incredere.
In primul rand ca nu inteleg limba :):)

resofty
29-01-09, 19:22
Era banal de gasit , dar daca numi trece prin cap ce sa faci...
Starbox Download:
http://www.starbox-digital.com/download/starbox5400/

Care ma ajuta si pe mine cu o explicatie

How to update to pay server.

Upgrade Pay SW with Upgrade Bootloader, use only STB Loader

1.switch on your box
2.make sure you have a channel list loaded, otherwise you may do a scan at the end .
3.make sure it is connected to your router
4.enable dhcp in your router, otherwise you have to input your box ip manually.
5.select autodetect
6.if you input your box ip manually, make sure you assign a free ip in the range of 000-254 (last block of your lan ip addresses)
7.push menu on remote
8.push 8888 on remote
9.go to installations
10.go to network setup
11.if dhcp is enabled, select autodetect
12.if dhcp is disabled, enter your lan data manually
13confirm your selection with ok box will reboot
14.after reboot fn key on remote returns information and weather.
15.select information.
16.information box pops up, saying ethernet plugged, ip address xxx.xxx.xxx.xxx, (which is your box ip in your lan), connection red box, status searching.
exit with exit
17.push menu on remote.
18.go installations
19.push fn on remote
20.enter your user id (free selection)
21.enter ip 218.xxx.xxx.xxx from manual or mybe no need
22.push blue key on remote
23.enter your access code manually and confirm with apply
24.wait for message registration successful
25.confirm with apply
26.exit menu
27.done.

ce nu inteleg e , cum e serverul platit ? horatiu cred ca ar sti mai bine sa imi explice cum sa rulez, fiindca vad ca treaba e ca si la echolite.