PDA

View Full Version : Topex cu openwrt cu boot de pe stick


battila
12-05-11, 21:59
Buna.

Am un router topex cu openwrt.Conform tutorialul lui Rsofty am facut sa booteaza de pe stick si am instalat cccam.
Cineva are un tutorial pentru instalare samba si mondtare hdd extern (NTFS)

Multumesc
sorin8m
12-05-11, 23:34
Instalare SAMBA

root@OpenWrt:/# opkg update
root@OpenWrt:/# opkg install luci-app-samba
Installing luci-app-samba (0.8.8-1) to root...
Downloading http://downloads.openwrt.org/kamikaz...8-1_mipsel.ipk
Connecting to 10.1.1.1:8080 (10.1.1.1:8080)
luci-app-samba_0.8.8 100% |*************************************************************************************************** ******| 2866 --:--:-- ETA
Installing samba3 (3.0.24-2) to root...
Downloading http://downloads.openwrt.org/kamikaz...4-2_mipsel.ipk
Connecting to 10.1.1.1:8080 (10.8.39.5:8080)
samba3_3.0.24-2_mips 100% |*************************************************************************************************** ******| 456k 00:00:00 ETA
Installing libpthread (0.9.29-14.3) to root...
Downloading http://downloads.openwrt.org/kamikaz...4.3_mipsel.ipk
Connecting to 10.1.1.1:8080 (10.1.1.1:8080)
libpthread_0.9.29-14 100% |*************************************************************************************************** ******| 19340 --:--:-- ETA
Configuring libpthread
Configuring luci-app-samba
Configuring samba3

preluat de pe alt forum, autorul tutorialului este tivcol


In legatura cu hdd exter partitionat NTSF, eu ti-as recomanda sal partitionezi EXT3, findca openwrt kamikaze (kernel 2.4) NTSF poate doar sal citesca nu si sa scrie (este READ ONLY, RO).

Dupa cum ai scris presupun ca ai instalat openwrt kamikaze kernel 2.4
battila
13-05-11, 16:25
Mersi Sorin.

Atunci de aia nu vede pe hard.Si o problema ca samba nu a aparut in webinterface.
battila
13-05-11, 23:30
Sorin,

Daca fac fat si nu ext3.O sa fie tot read only?
battila
14-05-11, 11:53
Primesc eroarea urmatoare cand dau comanda dmesg din putty.Totul am facut conform tutorial.
NU stiti de ce?

usb.c: USB disconnect on device 01:02.0-1.3 address 6
hub.c: new USB device 01:02.0-1.3, assigned address 7
WARNING: USB Mass Storage data integrity not assured
USB Mass Storage device found at 7
usb.c: USB disconnect on device 01:02.0-1.3 address 7
hub.c: new USB device 01:02.0-1.3, assigned address 8
WARNING: USB Mass Storage data integrity not assured
USB Mass Storage device found at 8
FAT: bogus logical sector size 0
FAT: bogus logical sector size 0
battila
14-05-11, 14:47
FAT: bogus logical sector size 0
FAT: bogus logical sector size 0
UDP: bad checksum. From 78.174.30.222:8403 to 192.168.0.3:41534 ulen 106
usb.c: USB disconnect on device 01:02.0-1.3 address 8
hub.c: new USB device 01:02.0-1.3, assigned address 9
WARNING: USB Mass Storage data integrity not assured
USB Mass Storage device found at 9


Nu stie nimeni raspunsul?
:)
battila
14-05-11, 23:43
root@OpenWrt:/# /etc/init.d/usbhdd start
Mounting USB drive: mount: mounting /dev/scsi/host0/bus0/target0/lun0/part1 on /share failed: Invalid argument


Stie cineva cum se rezolva problema?
birrbert
15-05-11, 13:05
Ce fel de hard disk ai?

Intreb fiindca eu am doua HDD-uri externe: unul de 2.5" si altul de 3.5". Primul n-are sursa, deci se alimenteaza prin portul USB, al doilea are sursa externa. Am constatat ca sursa micuta a routerului Bytton Topex nu poate alimenta un HDD extern prin USB.

Poate asta-i problema si la tine. Incearca un hard cu sursa proprie, si vezi daca reusesti.
battila
15-05-11, 13:51
Are sursa proprie.
zappa
15-05-11, 14:55
...mount: mounting /dev/scsi/host0/bus0/target0/lun0/part1 on /share failed: Invalid argument


Aici e tot secretul; " on /share failed: Invalid argument "
battila
15-05-11, 22:12
Bine Zappa.Zi-mi si mie care este secretul acolo.:P
battila
21-05-11, 00:09
Attached scsi disk sdb at scsi1, channel 0, id 0, lun 0
out of order segment: rcv_next 20A3A6BA seq 20A3A700 - 20A3A708
SCSI device sdb: 312581808 512-byte hdwr sectors (160042 MB)
/dev/scsi/host1/bus0/target0/lun0: p1 < p5 >

Asta am observat cand am dat comanda dmesg. Ce inseamna p5 la sfarsit?
zanga
07-09-11, 12:49
Ce fel de hard disk ai?

Intreb fiindca eu am doua HDD-uri externe: unul de 2.5" si altul de 3.5". Primul n-are sursa, deci se alimenteaza prin portul USB, al doilea are sursa externa. Am constatat ca sursa micuta a routerului Bytton Topex nu poate alimenta un HDD extern prin USB.

Poate asta-i problema si la tine. Incearca un hard cu sursa proprie, si vezi daca reusesti.

Dupa ce ai deconectat modemul GPRS ai rezolvat cumva si cu alimentarea HDD-ului?

Tvicol mai propunea o solutie:



Sursa interna de 5V am lasat-o nemodificata. In schimb am modificat sursa ajustabila.
Pentru a scoate 5V, R22 si R21 trebuiesc eliminate si in locul lor montati un rezistor de 4k7.
Scurt intre pinul 3 si pinul 5 de la LM2596adj pentru a trece stabilizatorul pe ON.

http://imageshack.us/f/593/img3512u.jpg/
sorin8m
08-09-11, 07:58
Eu vas recomanda hdd extern cu sursa proprie. Eu am unul de 1.5TB si merge perfect.
zanga
08-09-11, 15:13
Am incercat si eu cu un hdd extern de 1TB(cu alimentare proprie) si functioneaza perfect.
Totusi daca tot nu folosesc modemum GPRS as vrea sa ii folosesc alimentarea si sa las un hdd mai mic tot timpul(pentru ftp).